Near-inertial wave propagation between stratified and homogeneous layers: Data

Authors: (1) Hans van Haren, NIOZ Royal Netherlands Institute for Sea Research, P.O. Box 59, 1790 AB Den Burg, the Netherlands. Table of Links Abstract and Intro Data Observations Simulating Transition Discussion Conclusions and References 2 Data The four acoustic current meters also provided estimates of w, but these data are much noisier than the ADCP-w (Table 1). Therefore, most important parameters from these instruments are current components u and v, which are used for specifying the horizontal current polarization, and temperature T, which is used to monitor the variations in water mass properties with time, reflecting passages of eddies and newly formed dense water. Compared to the single good working mechanical current meter the acoustic devices showed larger amplitudes by 20%, as was inferred using the weak tidal amplitudes as measure. The mechanical current meter amplitude was corrected accordingly. During the deployment and recovery cruises shipborne SeaBird-911 ConductivityTemperature-Depth (CTD) profiles were obtained. These data are used for independent information on stratification variations in the vertical. Due to cable-limitations, the 2005- profile was stopped at z = -2500 m. This paper is available on arxiv under CC 4.0 license. Authors: (1) Hans van Haren, NIOZ Royal Netherlands Institute for Sea Research, P.O. Box 59, 1790 AB Den Burg, the Netherlands. Authors: Authors: (1) Hans van Haren, NIOZ Royal Netherlands Institute for Sea Research, P.O. Box 59, 1790 AB Den Burg, the Netherlands. Table of Links Abstract and Intro Abstract and Intro Data Data Observations Observations Simulating Transition Simulating Transition Discussion Discussion Conclusions and References Conclusions and References 2 Data The four acoustic current meters also provided estimates of w, but these data are much noisier than the ADCP-w (Table 1). Therefore, most important parameters from these instruments are current components u and v, which are used for specifying the horizontal current polarization, and temperature T, which is used to monitor the variations in water mass properties with time, reflecting passages of eddies and newly formed dense water. Compared to the single good working mechanical current meter the acoustic devices showed larger amplitudes by 20%, as was inferred using the weak tidal amplitudes as measure. The mechanical current meter amplitude was corrected accordingly. During the deployment and recovery cruises shipborne SeaBird-911 ConductivityTemperature-Depth (CTD) profiles were obtained. These data are used for independent information on stratification variations in the vertical. Due to cable-limitations, the 2005- profile was stopped at z = -2500 m. This paper is available on arxiv under CC 4.0 license. This paper is available on arxiv under CC 4.0 license. available on arxiv

Near-inertial wave propagation between stratified and homogeneous layers: Data

About Author

Comments

TOPICS

THIS ARTICLE WAS FEATURED IN

Related Stories

Untitled Story

Multiple Quantum Mpemba Effect: Exceptional Points and Oscillations: Appendix A: Eigenvectors

Near-inertial wave propagation between stratified and homogeneous layers: Abstract and Intro

Near-inertial wave propagation between stratified and homogeneous layers: Observations

Near-inertial wave propagation between stratified and homogeneous layers: Simulating transition

Near-inertial wave propagation between stratified and homogeneous layers: Discussion

Multiple Quantum Mpemba Effect: Exceptional Points and Oscillations: Appendix A: Eigenvectors

Near-inertial wave propagation between stratified and homogeneous layers: Abstract and Intro

Near-inertial wave propagation between stratified and homogeneous layers: Observations

Near-inertial wave propagation between stratified and homogeneous layers: Simulating transition

Near-inertial wave propagation between stratified and homogeneous layers: Discussion

Light-Mode

Classic

Newspaper

Dark-Mode

Neon Noir

Minty

HN StartUps