This paper is available on arxiv under CC 4.0 license.
Authors:
(1) Nicolas Bernal, New York University Abu Dhabi;
(2) Partha Konar, Physical Research Laboratory;
(3) Sudipta Show, Physical Research Laboratory.
In this section, two cases for the DM freeze-out are considered. The first corresponds to the visible freeze-out, where a couple of DM particles annihilate into a couple of SM states, with a total thermally-averaged annihilation cross section ⟨σv⟩. The evolution of the DM number density n can be described with the Boltzmann equation [20]
In the following, Eqs. (5.6) and (5.7) will be analytically solved in the context of a kination-like cosmology. For convenience, we start with the case corresponding to the dark freeze-out.
If the freeze-out occurs during the radiation-dominated era, Eq. (5.7) can be analytically solved, from the DM freeze-out until today (i.e., small temperature and therefore large x)
To match the whole observed DM relic density, it is required that
Alternatively, if the freeze-out happens during reheating
the integral has been split into two pieces, to emphasize the two regimes of H in Eq. (4.6). Therefore
The case of the visible freeze-out in Eq. (5.6) can be computed following the same procedure presented in the previous subsection. However, one could also derive it by fixing r = 2 in Eqs. (5.10) and (5.13), which gives
for the freeze-out in the radiation-dominated era, or
during reheating.
The freeze-out temperature can be estimated by comparing Eqs. (4.8) and (5.4) or (5.5), and is given by
Next, analytical solutions are presented for Eqs. (5.16) and (5.17) in the context of an early matter-dominated scenario. We will begin with the case corresponding to the dark freeze-out for convenience.
If the freeze-out occurs during the radiation era, the solution of Eq. (5.17), or equivalently of Eq. (5.7), is the one presented in Eq. (5.10). Instead, if it occurs during the reheating period, one has that
If the freeze-out occurs during radiation domination, the solution of Eq. (5.16) is the same as the one of Eq. (5.14). Alternatively, if it occurs during reheating, one has instead
simply corresponding to the limit r = 2 of Eq. (5.20).